Produkty dla konstrukcja wierzchnia (3)

GIPS SATYNOWY - Tworzy gładką i gładką powierzchnię.

GIPS SATYNOWY - Tworzy gładką i gładką powierzchnię.

Makes the surface ready for paint, saves paint. Oz does not. It is aesthetic. It is economical Water / Plaster Ratio:10 kg of plaster per 6 - 7 liters of water Usage Period:120 -160 minutes Freezing Time:300 - 350 minutes Consumption Amount:0.2 - 0.4 kg/m2 (every 1mm thick) Compressive Strength:> 3,0 N/mm2 (4x4x16 blok) Dry Unit Bulk Weight:680 - 720 kg/m3 Fire Response:A1 (According to TS EN 13279-1) Its Standard:TS EN 13279 Standard Type:C6 (Thin Applicable Plaster) Type:Polypropylene Bag PP5 Weight:30 kg + %2
GROSS PRIMER BETONOWY - Na bazie emulsji kopolimeru akrylowego, funkcja wypełniania powierzchni, barwiony pigmentem

GROSS PRIMER BETONOWY - Na bazie emulsji kopolimeru akrylowego, funkcja wypełniania powierzchni, barwiony pigmentem

Acrylic copolymer emulsion based, surface filling feature, colored Pigmented, mineral-added, High Adherence Concrete Primer is a colored primer that allows concrete wall and ceiling surfaces to be plastered with gypsum plaster. Thanks to its quartz sand-added formula, it strengthens the adhesion strength of gypsum and gypsum-lime-based liquids to concrete surfaces, and prevents rapid water loss of the plaster and the formation of cracks due to it. For indoor use, not recommended for use on damp and wet surfaces. Do not store below 5 0C Scope of application Especially on concrete-based surfaces, vertical and horizontal (column, curtain, wall, ceiling and similar) is used as adherence primer before gypsum plaster Drying:Drying time is at least 24 hours at 23 degrees and 50% relative humidity. is the hour. Thinning:With continuous mixing, 15%-20% of clean water is added. To mix up It is continued for 3 minutes fol
WYPEŁNIACZ SZCZELIN I PRIMER ZEWNĘTRZNY - Primer w stykach zewnętrznej płyty i na całej powierzchni. Jest używany

WYPEŁNIACZ SZCZELIN I PRIMER ZEWNĘTRZNY - Primer w stykach zewnętrznej płyty i na całej powierzchni. Jest używany

Surface preparation; Before starting the application, the surface should be cleaned of dust and anti-adhesive substances. The smoothness and mechanical health of the application surface should be checked. Application; The appropriate consistency of the mortar is 25 kg of joint filler in 5-7 liters of water. With a low-speed mixer, the joint filler is mixed into clean water for 3-5 minutes so that no lumps remain. The mortar, which is left to rest for 5 minutes, is mixed again for a short time and becomes ready for use. Physical Form:White Powder Water / Plaster Ratio:10 kg of gypsum in 6 liters of water Usage Period:80 - 100 minutes Freezing Time:130 minutes Dry Unit Bulk Weight:680 - 720 kg/m3 Fire Response:A1 (According to TS EN 13963) Type:PE Reinforced Kraft Bag Weight:25 kg + %2